Now there are two major thinr to do : 1)invoke the viewport toolbar to select(if available) 1"=20' or to manually input the 240 value and enter the input so as to scale the drawing within that viewport properly or 2) on command line invoke Z>S> 1/240XP and enter to scale that same viewport. Since you show a scale of 1"=20', that scale factor is = 20*12/1=240. ![]() Then go to the layout mentioned above and highlight the viewport where the barscale is and scale that part of the drawing. ![]() If you scale it the scale factor will be 80*12/80 or 12. Its total length s/b 80'but it shows at 6'8". ![]() 2334 eng- I checked out your drawing and I'll concentrate on the lower right hand drawing of layout "1 SITE PLAN".įirst back in model space your barscale is wrong.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |